How To Use A Electric Steam Wallpaper Remover Stripper

How To Use A Electric Steam Wallpaper Remover Stripper

1. With the machine plugged out, open the steam cap and fill the tank with water

2. Make sure to fully close the steam cap.

3. Turn the steam plate away from the user and plug in the machine

4. Wait for a few minutes while the steam builds up

5. Once the steam is being produced, simply press the steam plate to the wall for a few seconds and gently scrap away the wallpaper

6. When the user is finished with the machine, place the steam plate away from the user and unplug the machine. Wait a few minutes while the excess steam escapes.

7. Release the steam cap and either refill or leave to cool.

The 2200W 4.5L Electric Steam Wallpaper strippers is the most productive, safest and easiest to use steam Wallpaper Stripper.

The Wallpaper Stripper force steam through the layers of paper, helping to not only remove the paper but also glue residue from walls.The Wallpaper Steam Stripper is particularly effective on stubborn papers with paint on, or wood chip paper.

The 4.5L Electric Wallpaper Remover Stripper is much easier, compared to soak and scrap off the wallpaper manually, it only uses water which is heated.

Once the water boil then the water evaporates, produces steam out of the plate. The steam will penetrates into the wallpaper and loosen the old adhesive paste, so the wallpaper can then be pulled off and removed easily.

The advantages of removing wallpaper with steam are obvious: no need for chemicals, which is cheap and good for the environment. It's also much faster--you do not need to soak. BTW, no large puddles of water on the floor. What’s more, it makes work easier because large pieces can be removed from the wall.

The 2200W 4.5L Steam Wallpaper Stripper produces steam at just the right pressure and temperature for fast effective stripping with the minimum of condensation. Which reduces the risk of over-wetting wallboard or the plaster surface of the wall, and keeps the working environment comfortable.

The 4.5L Electric Wallpaper Stripper With overload protector which allows the excess steam to be released, to protect your safety.

Simply fill with hot or cold tap water and connect to the power supply. The Electric Wallpaper Stripper will steam-up in 15 minutes and continue to run for around 70 minutes, before switching off automatically when a low water level is reached.

The user then simply disconnects the Wallpaper Stripper from the power supply, waits 2 minutes to allow the steamer to cool, and then refills. This eliminates the need for the user to remember to constantly check the water level. Even if it is left connected to the power supply with a low water level it will safely switch on and off as the heating element cools down and heats up.